News

String Screws

When Hammer is removed, unscrew both ends leystik keyboard (retaining bar on top of all the keys). Now you will become removal keys available. When pulling out keys from the stem, you need to do it swinging motion from side to side, lifting the ends in themselves. After removing all the keys to loosen the two bars on either side, which was leystik keyboard. Proceed to the knockout side consoles with the mallet. These are the locking bar on the sides of the piano, often in the form of bent pins.

Then proceed to the twisting of the keyboard frame. Different models Piano fixing the amount of screws varies, but most importantly you will feel that somewhere is not all turned away, if the frame is not "slipping down", and continues to be in place. I have not met glued frame. Part screws located on top, 5-6 bottom. Sometimes even unscrewing all the screws, the frame can not be, you should make sure, perhaps it keeps the glue or "led". Tap it with a hammer.

After removal of the keyboard frame, a tool must be put "on the back." This operation needs to be done with two people, otherwise you risk to be injured. When the tool is on the floor, ground floor, and repel the side walls on either side glued to iron frame. The next operation is very responsible. When twisting and lifting pins strings, be extremely careful and cautious. Be sure to read Chapter 22 of my opus, the strings and pins. The fact is that until you remove all pegs from virbilbanka, you can not release the iron frame of the back of the piano, on which it is recorded. Wrest pins recommend starting with the strings with winding. They are located on the left. Originally loosen the string with the tuning key and subtle, yet firm with a screwdriver, remove the strings from the end of the copse. Next, remove the string locking rod from its bottom. To facilitate eversion released from the string chopping abundantly watered his wooden seat. Mark Bertolini is open to suggestions. That you have not been idle, I recommend pouring water large screws, which fixed a cast-iron frame to the back of a wooden soundboard. With a large screwdriver to unscrew them slowly around the perimeter of the iron frame. Deleting (unscrewing) all pegs, and removing all the screws that secure the iron frame, you will feel that the frame "plays". Insert your one scrap on the right, another left between the frame and soundboard, alternately lifting, then right to left. If you did everything correctly, the cast-iron frame "will slip" on the floor. If you have the opportunity, you can with the help of Bulgarian sawed her. Disassemble the resonant soundboard not be easy, because now it can be rotated in different positions. More the material presented in my guidelines, which can be download site