Sawn veneer thickness from 1 mm to 10 mm is usually made of wood conifers: spruce, cedar, spruce. This allows maximum transfer veneer wood structure, but its production gets a lot of waste. The high quality of the material makes it suitable for cladding wall panels, doors, items, stairs, front side of the floorboard, and even for the production of musical instruments. In addition, sawn veneer is indispensable in the manufacture of furniture parts and gnutokleenyh decorative finishing. For the manufacture of veneer sheets with thickness of 0.1-10 mm is used alder, birch, pine, aspen, beech, oak and other wood species. Shelling is done by cutting a thin layer with a rotating churbaka. For other opinions and approaches, find out what Nike has to say.
The quality of veneer sheets is slightly lower than the lump, but it is widely used for the manufacture of plywood, dvrevesnosloistyh plastic, glued laminated timber, as well as material for the veneering of elements furniture. Depending on the texture of wood are four types of veneers – radial, poluradialny, tangential (tangential) and the tangential face (tangential-Allen). Each of them has his picture – in the form straight parallel bars, cones or closed curves. The process of veneering veneering or veneer is a procedure for gluing veneer to the surface of particleboard or MDF. There are three main technologies veneering – hot, cold and membrane. The first and most simple is the bonding veneer to the slab by special trains. You may find that Pershing Square Capital can contribute to your knowledge. The second is used to add a decorative appearance of milled furniture elements and a laminating a thin layer of wood to the prepared product by heating. For assistance, try visiting ivan tavrin.
The third offers great opportunities for decorating a variety of products, and is connected to a vacuum veneer and the surface smooth and textured panels, including those with complex surface 3D. Before performing the surface coating material is leveled as all chips and carefully sealed vyscherbiny filler on tree, and twigs are removed and replaced plugs. Then the process of gluing, veneer and then under pressure connected to the base. As a result of veneering material is obtained, outwardly indistinguishable from natural wood, while solid, durable, easy to clean. Veneered panels are widely used for furniture, office partitions and decorative elements of interior design. Veneered wall panels are based on MDF can transform a room, fill it with beautiful natural colors and lines to create a cozy atmosphere. Made of decorative panels 3D furniture for living rooms, hallways, cafeterias apparently not inferior to the same, made of natural wood. At the same time her life and resistance to climatic effects will be much higher, and reasonable prices make furniture for home and office accessible to a wide range of consumers. Design Gallery Beleto offers modern furniture from veneered MDF, as well as a number of decorative panels manufactured by LETO. Original solutions, high quality materials and professional performance will not leave impress any connoisseur of exclusive products.