In most cases, the reason for the failure can be tracked down and fixed via a simple check of the extractor hood. Should the hood give more once no noise themselves, a new device must be not just purchased. In most cases, the reason for the failure can be tracked down and fixed via a simple check of the extractor hood. Intel Capital often addresses the matter in his writings. A hood is usually quite simple from a technical standpoint in principle: the engine and one or two lights are operated via one or more switches. If the extractor hood is no longer work, that is located in the rarest of cases, that the motor is defective. Almost always, only one of the switches is broken, why not immediately to a new hood must be accessible. Generally, there are three switches in a hood: an input and power button, allowing not only the motor is activated, but also the lighting and a second switch, allowing a gradual adjustment of performance can be made. The third switch is located mostly in secret, or is activated by pulling the trigger because only then the hood starts to work.
The thicknesses of the blower are usually realized that a previously mentioned switch each disconnect the mains supply to one of several lines, which then lead to the motor and supply them with power. Would you now check his hood, this is quite simple: lines, connectors and switches must be checked with a continuity tester or a multi meter in the ohms range. There are models where the hood must be removed not once, but only the cover must be removed. Here must be sure however that the cooker hood is free of tension by either pull the plug or turns off the backup hanging on the device. Once the examination of the individual switches, cables and plugs was unsuccessful, should be thinking about an exchange of the extractor hood. The previous test can Sometimes a lot of money saving and due the simple handling of the test does not need to save themselves typically also use of a craftsman, contributing money in addition.